Powerstop 2023-2024 Ford F250 Super Duty 4WD Power Stop Z36 Truck & Tow Complete Brake Kit

PowerStop is on a mission to deliver an easy and affordable way for any driver to upgrade their brakes - no matter where or how they use their vehicle. Our Z36 Truck & Tow Brake Upgrade Kit is recommended for trucks, 4x4s, and SUVs that not only work hard, but play hard as well. This brake pad and rotor kit comes with everything you need, including premium stainless-steel hardware, for an easy, bolt-on installation. The low-dust Ceramic brake pads are reinforced with Carbon-Fiber to provide severe-duty stopping power without sacrificing everyday drivability. These pads are paired with Drilled & Slotted rotors that keep brake temperatures down by maximizing heat dissipation, critical for those long mountain descents. Whether towing a boat or trailer, hauling for the jobsite, or tackling a tough off-road trail, get the easy and affordable, bolt-on performance upgrade with the Z36 Truck & Tow Brake Upgrade Kit.

• Towing
• Hauling
• Big Tire Upgrades
• Mountain Driving
• Off-Road

Break-In is critical for optimal performance

The break-in procedure is critical to brake performance. The reason for a proper break-in is to establish an even layer of friction material deposited on the rotors from the brake pads. It is very important that this initial layer of friction material is evenly distributed.

1:28

0:17

Break in your PowerStop Brakes as follows:

• 1

  Complete 5 moderate to aggressive stops from 40 mph down to 10 mph in rapid succession without letting the brakes cool and do not come to a complete stop. If you're forced to stop, complete the stop and either shift the vehicle into park or give room in front so you can allow the vehicle to roll slightly while waiting for the track light. The rotors will be very hot and holding down the brake pedal will force the brake pad to contact the rotor and possibly create an imprint on the rotor. This imprint may contribute to the creation of brake judder.

• 2

  Continue the break in by completing 5 moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool. You should expect to smell some resin as the brakes get hot. After this is complete, continue to drive the vehicle for as long as possible without heating the brakes excessively and without coming to a complete stop (Try for about 5 minutes at moderate speed). This is the cooling stage.

• 3

  Once this is completed and the brakes have cooled to standard operating temperature, you may use the brakes normally. Never cool your brakes with water, as this can damage them.